Titanium Era Sizing Guide

The best way to determine your finger size is to visit at least one reputable jeweler. A second opinion is advised.

Some jewelers may disagree, but often there are discrepancies in the sizing tools made by different manufacturers.


If you want to place an online order to guarantee the sale price, you can do so, in the comment box clearly explain that you will call us back with the correct size, once determined by a jeweler. We will hold the order for a maximum of one week.

Most jewelers will have the following finger sizing tools.


Jeweler’s finger sizing tools


The narrow set should be used if you intend on wearing a narrow band, 5mm ring width or less.

The wider set should be used if you intend on wearing a band 6mm width or more.



If you are measured using the narrow sizing set, and plan to wear a wide band
(6mm or wider), you should add 0.25 or 0.5 more to the size.


Accurate ring sizing can be tricky. Everyone has different shaped fingers and knuckles. A well fitting ring should sit comfortably on the finger, and have some resistance coming off. Everyone’s hands changes throughout the day, swelling does occur. The best time of day to have your finger sized is in the afternoon.



If you are unsure about the exact size, it is always best to go with the slightly smaller size. We can increase a ring by a 0.25 size larger, but if it ends up too big it has to be remade.


Jewelers use two different methods of measuring.


Some jewelers measure from the center line of where the ring falls on the mandrel.



Other jewelers measure from the bottom line of the ring, where it lands on the ring mandrel. At Titanium Era, we use this method. The rings in the picture below measure American size 8 and 10 using our sizing method. All rings made by Titanium Era are comfort fit; the inside edges are rounded for a smooth comfortable fit.



Ring sizing mandrel


Titanium Era uses American/Canadian sizing to make all its rings, we offer a general size conversion table for other methods of sizing.

Titanium Era is not responsible for wrong sizes determined by customers using other companies sizing methods. IE: paper or string methods, etc. (These are NOT accurate)

Please note, European or International methods of sizing do not correspond exactly to North American sizing.

The most accurate way for European or International customers to determine their ring size is by using the inside diameter method. (In the comment box on the order form, give us the sizing ring diameter in mm’s to the second decimal point.) The sizing ring used for measuring should be the same width as the ring being ordered.



Conversion Chart